The outline, installation dimension and sealing method of BS12 is strongly interchangeable, it is widely used for measuring pressure which is compatible with stainless steel and Viton;

Put general BS12 pressure sensor into the housing with standard or special thread; use face type seal or waterline seal; with flexible construction and strict inspecting and screening; the assembled.BS12N sensor has similar application with general type sensor, it can be used for mounting and production of different pressure instruments;

Put general BS12 pressure sensor into the housing with standard or special thread; and weld sensor with housing together,no O-ring for sealing. The whole product has flexible construction, it has wider application fields than general pressure sensor, can be used for mounting and production of different pressure instruments;

Flush diaphragm pressure sensor is a full-welded pressure sensor, it has pressure port G1/2 male or M20x1.5 male, sealing by Viton O-ring at the end of thread. The isolated diaphragm is welded in front of thread port, the whole measure range is 0~100kPa…35MPa. It can be used for food, medicine,sanitation fields in which the media is easily dirty.

We can use general type, assembled type as well as flash diaphragm type gauge pressure sensor to measure pressure below air pressure, the min. pressure can be around -100kPa.

ElectricPerformance
Powersupply	1.5mA(typ.)
Electricconnection	Kovar pin or 100mm silicon rubber flexible wires
Common mode voltage output	50% of input (typ.)
Input impedance	2kΩ~6kΩ
Output impedance	2kΩ~6kΩ
Insulation resistor	250MΩ, 250VDC
Overpressure	<6MPa, 2 times FS; (6~60)MPa, 1.5times FS; Differential pressure or Low pressure range1.3times FS
Construction
Diaphragm	stainless steel 316L
Housing	stainless steel 316L
Pin	Kovar
O-ring	Viton
Net weight	~30g(general type)
~50g(flush diaphragm)
~150g(assembled type)
EnvironmentCondition
Position		Deviate 90° from any orientation, zero change≤0.05%FS
Impact		100g, 11ms
Media compatibility		The gas or liquid which is compatible withconstruction material and Viton
BasicCondition
Media temperature		(25±1)℃
Environment temperature		(25±1)℃
Shock		0.1g (1m/s/s)Max
Humidity		(50%±10%)RH
Local air pressure		(86~106)kPa
Power supply		(1.5±0.0015)mADC